Radial X-Amp aktívny

Radial X-Amp

The Radial X-Amp is an active re-amping device that lets you use a a pre-recorded track from a line level device to drive two guitar amplifiers or effect pedals simultaneously. This opens the door to explore new musical sounds and spur on the creative process. Re-amping is one of those producer's tricks for bringing new sounds and textures to already recorded tracks, and the X-Amp is designed to to the job well. This active re-amping device features a Class-A signal path, an input level overload indicator, an isolated output to get rid of ground loops, and a variable output level control. Add a new wrinkle to your recordings with the X-Amp!

Features:

• 14-Gauge steel welded I-beam construction makes it impossible to torque the PC board.
• Class-A active circuit for transparency and lowest possible noise.
• Ground lift switch - recessed to prevent accidental use.
• Audio Transformer provides 100% isolation to eliminate hum and noise caused by ground loops.
• Heavy duty connectors and switches - high cycle for reliable performance.
• Military spec PC board with full surface ground plane to reduce RF noise susceptibility.
• INPUT - Balanced LINE LEVEL XLR input connector, normally connected to recorder output. A dry guitar track would be a typical source signal.
• GROUND - INPUT SIDE lifts pin-1 ground at the XLR-in to help eliminate ground loops that can cause buzz and hum in a sound system.
• POWER - X-Amp comes equipped with a 15VDC 400mA power supply. Optional 100V, 110V, 220V and 240V PSUs are available.
• Full bottom rubber pad - provides plenty of stay-put wherever you place the X-Amp. Also electrical isolation from amp handles etc.
• Book-cover design creates a protective zone around switches & connectors - Indestructible 14-gauge steel construction with baked enamel finish.
• Power LED - lets you know the X-amp is on and ready to use.
• LEVEL control - adjusts the X-Amp level going to your amp or effects to match that of your guitar; get the exact sound as plugging directly in!
• CLIP LED - provides visual cue of input signal overload.
• OUT-1-1/4" DIRECT feed from the X-Amp's Class-A circuit. This output should always be used to ensure proper grounding.
• POLARITY - 180-degree reverse on the isolated OUT-2 to correct the phase with an amp or device connected on OUT-1.
• OUT-2 - 1/4" ISOLATED 2nd output to another amp or effect(s). Transformer isolation eliminates the hum and buzz caused by ground loops.
• Ground Lift switch on output - lifts ground between OUT-2 and OUT-1. Side mounted switch is recessed to prevent accidental use.

Specifications:

• Type: Active Re-amping Device
• Channels: 1
• Inputs: 1 x XLR
• Outputs: 2 x 1/4"
• Height: 2"
• Depth: 5.5"
• Width: 3.5"
• Weight: 2 lbs.